Without Scan Tool

DTC CHECK (SST CHECK WIRE)

DTC Check




1. Using SST, connect terminals TC and CG of the DLC3.

SST 09843-18040

2. Turn the ignition switch on (IG).
3. Read the DTCs from the ABS warning light on the combination meter.

HINT: If no code appears, inspect the TC and CG terminal circuit and the ABS warning light circuit.

Trouble Area
TC and CG terminal circuit
ABS warning light circuit (Remains on)
ABS warning light circuit (Does not come on)




4. As an example, refer to the chart for the blinking patterns of the normal system code and trouble codes 11 and 21.
5. The codes are explained in the code table.
6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK

a. Turn the ignition switch on (IG).
b. Check that the ABS warning light goes off within approximately 3 seconds.