Front Seat Assembly (For Manual Seat)

FRONT SEAT ASSEMBLY (For Manual Seat)

Front Seat Assembly (for Manual Seat):

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.

2. REMOVE FRONT SEAT HEADREST ASSEMBLY
3. REMOVE SEAT TRACK COVER
a. Move the front seat assembly fully forward by operating the slide handle.
b. Using a screwdriver, disengage the 4 claws and remove the seat track cover.

HINT: Tape the screwdriver tip before use.

4. REMOVE INNER SEAT TRACK BRACKET COVER

a. Using a screwdriver, disengage the 4 claws and remove the inner seat track bracket cover.

HINT: Tape the screwdriver tip before use.

5. REMOVE FRONT SEAT ASSEMBLY
a. Move the front seat assembly to the rearmost position by operating the slide handle.
b. Remove the 2 bolts on the front seat track bracket.

c. Move the front seat assembly fully forward by operating the slide handle.
d. Remove the 2 bolts on the rear seat track bracket.

e. Move the front seat assembly to the center position and adjust the seatback to the vertical position by operating the slide and reclining adjuster release handle.
f. Disconnect the connectors and clamp.
g. Remove the front seat assembly.

INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY
a. Place the front seat assembly in the vehicle and align the adjuster pin with the hole on the vehicle side.
b. Connect the connector and clamp.
c. Move the front seat assembly to the rearmost position by operating the slide handle.

NOTICE: Check that the seat is locked.

d. Temporarily install the front seat track bracket with the 2 bolts.

e. Move the front seat assembly fully forward by operating the slide handle.

NOTICE: Check that the seat is locked.

f. Temporarily install the rear seat track bracket with the 2 bolts.
g. Move the front seat assembly to the rearmost position by operating the slide handle.

NOTICE: Check that the seat is locked.

h. Fully tighten the 2 bolts on the front seat track bracket in the order of the inner side bolt and then the outer side bolt.

Torque: 37 N.m (377 kgf.cm, 27 ft.lbf)

i. Move the front seat assembly fully forward by operating the slide handle.

NOTICE: Check that the seat is locked.

j. Fully tighten the 2 bolts on the rear seat track bracket in the order of the inner side bolt and then the outer side bolt.

Torque: 37 N.m (377 kgf.cm, 27 ft.lbf)

2. INSTALL INNER SEAT TRACK BRACKET COVER

a. Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
b. Push the seat track bracket cover inner to engage claw B.

3. INSTALL SEAT TRACK COVER

a. Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
b. Push the seat track cover to engage claw B.

4. INSTALL FRONT SEAT HEADREST ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT SLIDE ADJUSTER LOCK
7. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Seat)
8. INSPECT SRS WARNING LIGHT
Check the SRS warning light.