Interior - Shifter Trim Squeaking Noises
T-SB-0054-09January 29, 2009
Shifter Trim Squeak Noise
Service Category
Vehicle Interior
Section
Interior Panels/Trim
Market
USA
Applicability
TSB SUPERSESSION NOTICE
The information contained in this TSB supersedes TSB No. NV005-07.
^ The production change information and parts information sections have been updated.
TSB No. NV005-07 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.
Introduction
Some 2007 model year Camry and Camry HV customers may complain of a squeak noise coming from the shifter trim area on automatic transmission equipped vehicles. Use the repair procedure below to correct this condition.
Production Change Information
This TSB applies to vehicles produced BEFORE the Production Change Effective VINs shown below.
Warranty Information
APPLICABLE WARRANTY
^ This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle's in-service date.
^ Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Required Tools & Equipment
NOTE
Additional SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.
Parts Information
Felt Locations
The shifter trim is now available as an assembly in the parts system. The new assembly includes felt added at various locations to prevent noise.
The following illustrations show the modifications to the trim assembly to improve noise condition.
Repair Procedure
1. Order a NEW shifter trim assembly (called "Housing Assembly Position Indicator" in the parts system) using the part number from the Parts Information table of this TSB.
2. Remove and replace the old shifter trim assembly with the NEW part. Refer to the Technical Information System (TIS)
2007 Camry Repair Manual Vehicle Interior - Interior Panels/Trim - "Instrument Panel: Instrument Panel Safety Pad: Removal".
2007 Camry HV Repair Manual Vehicle Interior - Interior Panels/Trim - "1nstrument Panel: Instrument Panel Safety Pad (for TMC Made): Removal".
2007 Camry HV Repair Manual Vehicle Interior - Interior Panels/Trim - "Instrument Panel: Instrument Panel Safety Pad (for TMMK Made): Removal".
A. Remove the shift lever knob sub-assembly by turning the shift lever counterclockwise.
B. Remove the No. 1 instrument finish panel garnish by disengaging the 2 clips (LH side).
C. Remove the No. 1 instrument finish panel garnish by disengaging the 2 clips (RH side).
D. Remove the floor shift position indicator housing sub-assembly by disengaging the 6 claws and the 3 clips.
With Seat Heater System:
Disconnect the connector.
3. Replace the shifter trim assembly and reassemble in reverse order of disassembly.
4. Confirm repair.