Removal and Replacement

FRONT BUMPER

Front Bumper:

Front Bumper:

Front Bumper:

Front Bumper:

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)






a. Remove the 7 clips and cool air intake duct seal.

2. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)






a. Put protective tape around the front bumper assembly.
b. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.






HINT: Use the same procedures for the RH side and LH side.

c. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.






d. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.






HINT: Use the same procedures for the RH side and LH side.

e. Remove the front bumper assembly.

3. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)






a. Put protective tape around the front bumper assembly.
b. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.






HINT: Use the same procedures for the RH side and LH side.

c. Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.






d. Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.






HINT: Use the same procedures for the RH side and LH side.

e. Disconnect each connector, and then remove the front bumper assembly.

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light)






a. Engage each claw.
b. Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
c. Install the pin hold clip.






HINT: Use the same procedures for the RH side and LH side.

2. INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light)






a. Connect each connector.
b. Engage each claw.
c. Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
d. Install the pin hold clip.






HINT: Use the same procedures for the RH side and LH side.

3. INSTALL COOL AIR INTAKE DUCT SEAL (for 2GR-FE)





a. Install the cool air intake duct seal with the 7 clips.

4. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light)
5. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light)
6. INSPECT FOG LIGHT AIMING (w/ Fog Light)
7. ADJUST FOG LIGHT AIMING (w/ Fog Light)