Removal and Replacement

Temperature Control Switch:

TEMPERATURE CONTROL SWITCH

REMOVAL

HINT: Installation is in the reverse order of removal.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
a. Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2
3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER




a. Release the 8 claws and 5 clips and instrument cluster finish panel sub-assembly center.
b. Disconnect the connector and remove the instrument cluster finish panel sub-assembly center.

INSTALLATION

1. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM SYSTEM INITIALIZE
a. Some systems need initialization when disconnecting the cable from the negative battery terminal.