Remote Switch: Service and Repair

Steering Pad Switch:

Steering Pad Switch:

STEERING PAD SWITCH

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE STEERING WHEEL COVER LOWER NO. 2
4. REMOVE STEERING WHEEL COVER LOWER NO. 3
5. REMOVE STEERING PAD
6. REMOVE STEERING PAD SWITCH ASSEMBLY




a. Disconnect the connector.
b. Remove the 2 screws and remove the clamp.
c. Disengage the 4 pins and remove the steering pad switch assembly.

INSTALLATION

1. INSTALL STEERING PAD SWITCH ASSEMBLY
2. INSTALL STEERING PAD

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Some systems need initialization when disconnecting the cable from the negative battery terminal.

4. PERFORM SYSTEM INITIALIZE
5. INSPECT STEERING PAD
6. INSPECT SRS WARNING LIGHT