Curtain Shield Airbag Assembly
Curtain Shield Airbag Assembly:
Curtain Shield Airbag Assembly
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read the "Restraint Systems; Service Precautions" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY".
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
a. Remove the curtain shield airbag assembly LH in order shown in the illustration.
1. Remove the 9 bolts in order of A to I.
b. Disconnect the connector from the curtain shield airbag assembly LH.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
NOTE: Do not twist the curtain shield airbag assembly LH when installing it.
a. Connect the connector to the curtain shield airbag assembly LH.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
b. Install the curtain shield airbag assembly LH in the order shown in the illustration.
1. Install the 9 bolts in order of A to I.
Torque:Bolt D
11 N.m (112 kgf.cm, 8 ft.lbf)
Bolt A, B, C, E, F, G, H, I
13 N.m (133 kgf.cm, 10 ft.lbf)
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY".
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
5. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.