Tire Pressure Monitor Receiver / Transponder: Service and Repair

TIRE PRESSURE WARNING RECEIVER (w/ Antenna)

COMPONENTS (Part 1):

COMPONENTS (Part 2):

REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR SEAT CUSHION ASSEMBLY
3. REMOVE REAR SEAT HEADREST ASSEMBLY
4. REMOVE REAR SEATBACK LOCK COVER CAP
5. REMOVE REAR SEATBACK ASSEMBLY LH
6. REMOVE REAR DOOR SCUFF PLATE LH
7. REMOVE REAR SEAT SIDE GARNISH LH
8. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH





9. REMOVE TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a) Disconnect the connector.





(b) Remove the bolt and the tire pressure warning receiver assembly.

INSTALLATION





1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a) Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf)





(b) Connect the connector.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
3. INSTALL REAR SEAT SIDE GARNISH LH
4. INSTALL REAR DOOR SCUFF PLATE LH
5. INSTALL REAR SEATBACK ASSEMBLY LH
6. INSTALL REAR SEATBACK LOCK COVER CAP
7. INSTALL REAR SEAT HEADREST ASSEMBLY
8. INSTALL REAR SEAT CUSHION ASSEMBLY
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. PERFORM INITIALIZATION

NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal.

11. INSPECT TIRE PRESSURE WARNING SYSTEM