Programming and Relearning

PRECAUTION

1. INITIALIZATION

NOTE:
- When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.

System Name
Power Window Control System
Sliding Roof System

- Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
- Perform REGISTRATION (VIN registration) when replacing the ECM. Engine Control System - SFI System

2. EXPRESSION OF IGNITION SWITCH






HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table are used in this section.

3. FOR USING INTELLIGENT TESTER

CAUTION: Observe the following items for safety reasons:
- Before using the tester, read the instruction manual.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.

4. FOR USING BATTERY DURING INSPECTION
a. While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.