Rear Axle Hub and Bearing
REAR AXLE HUB AND BEARINGCOMPONENTS:
ON-VEHICLE INSPECTION
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
3. REMOVE REAR DISC
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
NOTICE: Ensure that the dial indicator is set at right angles to the measurement surface.
If looseness exceeds the maximum, replace the axle hub assembly.
5. INSPECT REAR AXLE HUB RUNOUT
(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0027 in.)
NOTICE: Ensure that the dial indicator is set at right angles to the measurement surface.
If runout exceeds the maximum, replace the axle hub assembly.
6. INSTALL REAR DISC
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
8. INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
REMOVAL
HINT:
^ Use the same procedures for the RH side and LH side.
^ The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Remove the bolt and separate the flexible hose from the shock absorber.
(b) Remove the 2 bolts and separate the rear disc brake caliper assembly LH.
NOTICE: Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.
3. REMOVE REAR DISC
4. DISCONNECT SKID CONTROL SENSOR
(a) Disconnect the skid control sensor connector.
5. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Remove the 4 bolts and hub & bearing assembly LH.
INSTALLATION
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf)
2. CONNECT SKID CONTROL SENSOR
(a) Connect the skid control sensor connector.
NOTICE: Do not twist the sensor wire when connecting it.
3. INSPECT REAR AXLE HUB BEARING LOOSENESS
4. INSPECT REAR AXLE HUB RUNOUT
5. INSTALL REAR DISC
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Install the rear disc brake caliper assembly LH with the 2 bolts.
Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf)
NOTICE: Do not twist the brake hose when installing the rear disc brake caliper assembly LH.
(b) Install the rear flexible hose with the bolt.
Torque: 19 N*m (192 kgf*cm, 14 ft.*lbf)
7. INSTALL REAR WHEEL
Torque: 103 N*m (1.050 kgf*cm, 76 ft.*lbf)
8. ABS SPEED SENSOR SIGNAL