Removal and Replacement

Combination Meter:

Combination Meter

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.1
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2




4. REMOVE INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)
a. Remove the instrument panel finish plate.




5. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
a. Using a moulding remover, disengage the 4 claws and 6 clips then remove the instrument panel subassembly.

6. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER




7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
a. Remove the 4 screws.




b. Using a moulding remover, disengage the 5 clips and remove the instrument cluster finish panel subassembly.




8. REMOVE COMBINATION METER ASSEMBLY
a. Remove the 4 screws.
b. Pull out combination meter assembly, then disconnect the connectors.

INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
5. INSTALL INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)
6. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2
7. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.1
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION
a. Some systems need initialization when disconnecting the cable from the negative battery terminal.