Ignition Timing: Testing and Inspection
INSPECT IGNITION TIMINGa. Warm up the engine.
b. When using the intelligent tester:
Check the ignition timing.
1 Connect the intelligent tester to the DLC3.
2 Enter DATA LIST MODE on the intelligent tester.
Ignition timing: 8 to 12° BTDC @ idle
HINT: Please refer to the intelligent tester operator's manual for help on selecting the DATA LIST
c. When not using the intelligent tester:
Check the ignition timing.
1 Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
SST 09843-18040
NOTICE:
^ Confirm the terminal numbers before connecting them. Connection with a wrong terminal can damage the engine.
^ Turn off all electrical systems before connecting the terminals.
^ Perform this inspection after the cooling fan motor is turned off.
2 Remove the V-bank cover.
3 Pull out the wire harness as shown in the illustration.
4 Connect the tester terminal of the timing light to the engine.
NOTICE: Use a timing light which can detect the first signal.
5 Check the ignition timing at idle.
Ignition timing: 8 to 12° BTDC @ idle
NOTICE: When checking the ignition timing, the transmission should be in the neutral position.
HINT: Run the engine at 1,000 to 1,300 rpm for 5 seconds, and then check that the engine rpm returns to idle speed.
6 Disconnect terminals 13 (TC) and 4 (CG) of the DLC3.
7 Check the ignition timing at idle.
Ignition timing: 7 to 24° BTDC @ idle
8 Confirm that ignition timing moves to the advanced angle side when the engine rpm is increased.
9 Remove the timing light.