Pinout Values and Diagnostic Parameters

TERMINALS OF ECU

1. DLC3







a. Check DLC3.
1. Measure the resistance according to the value(s) in the table above.

2. SKID CONTROL ECU







a. Check skid control ECU.
1. Disconnect the connector (S1) from the skid control ECU.
2. Measure the resistance according to the value(s) in the table above.







b. Check the skid control ECU harness side connector (S1).
1. Disconnect the connector (S1) from the skid control ECU.
2. Measure the resistance according to the value(s) in the table above.

3. STEERING SENSOR







a. Check steering sensor.
1. Disconnect the connector (S12) from the steering sensor.
2. Measure the resistance according to the value(s) in the table above.







b. Check the harness side connector (S12) of the steering sensor.
1. Disconnect the connector (S12) from the steering sensor.
2. Measure the resistance according to the value(s) in the table above.

4. YAW RATE SENSOR







a. Check the yaw rate sensor harness side connector (Y1).
1. Disconnect the connector (Y1) from the yaw rate sensor.
2. Measure the resistance according to the value(s) in the table above.







5. JUNCTION CONNECTOR (J13)
a. Terminal arrangement and connection