Transmission Control Cable Assy
TRANSMISSION CONTROL CABLE ASSEMBLY (A245E)REPLACEMENT
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
4. REMOVE CONSOLE PANEL UPPER
5. REMOVE CONSOLE BOX CARPET
6. REMOVE CONSOLE BOX SUB-ASSEMBLY REAR
7. REMOVE AIR BAG SENSOR ASSEMBLY CENTER
8. DISCONNECT OXYGEN SENSOR CONNECTOR
a. Remove the foot rest.
b. Pull up the floor carpet.
c. Disconnect the oxygen sensor connector.
9. REMOVE FLOOR PANEL BRACE FRONT
a. Remove the 2 nuts and floor panel brace.
10. REMOVE EXHAUST PIPE ASSEMBLY FRONT
11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1
a. Remove the 3 nuts and heat insulator.
12. REMOVE AIR CLEANER CASE
13. REMOVE AIR CLEANER HOSE NO.1
14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
a. Remove the nut from control shaft lever.
b. Disconnect the control cable from the control shaft lever.
c. Remove the clip and disconnect the control cable from the control cable bracket.
d. Disconnect the control cable from the control cable support.
e. Remove the 2 nuts.
f. Remove the cable end from the rod of the floor shift assembly.
g. Using a screwdriver, disconnect the control cable from the shift lever plate.
HINT: Tape up the screwdriver tip before use.
h. Remove the 2 bolts.
i. Pull out the control cable assembly from the body.
j. Remove the retainer from the shift cable.
15. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
a. Install the retainer to the shift cable.
b. Pull in the control cable assembly to the body.
c. Install the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
d. Install the control cable to the shift lever plate.
e. Install the cable end to the rod of the floor shift assembly.
HINT: Install it with the uneven surface facing upward.
f. Install the control cable with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
g. Connect the control cable to the control cable support.
h. Temporarily install the control cable to the control shaft lever with the nut.
i. Install the control cable and clip to the bracket.
16. INSTALL AIR CLEANER HOSE NO.1
17. INSTALL AIR CLEANER CASE
18. INSTALL FRONT FLOOR HEAT INSULATOR NO.1
a. Install the heat insulator with the 3 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 inch lbs.)
19. INSTALL EXHAUST PIPE ASSEMBLY FRONT
20. INSTALL FLOOR PANEL BRACE FRONT
a. Install the floor panel brace with the 2 nuts.
Torque: 30 Nm (302 kgf-cm, 22 ft. lbs.)
21. INSTALL OXYGEN SENSOR CONNECTOR
a. Connect the oxygen sensor connector.
b. Install the floor carpet and foot rest.
22. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
23. ADJUST SHIFT LEVER POSITION
24. INSPECT SHIFT LEVER POSITION
25. INSPECT SRS WARNING LIGHT