Rear Left Sensor

Air Bag Sensor Rear LH:

REPLACEMENT

HINT: Use the same procedures for the RH side and LH side.

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

3. REMOVE REAR SEAT CUSHION ASSEMBLY
4. REMOVE REAR SEATBACK ASSEMBLY LH (SEPARATED TYPE REAR SEAT)
5. REMOVE REAR SEATBACK ASSEMBLY (FIXED TYPE REAR SEAT)




6. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector from the airbag sensor rear LH.
b. Remove the nut and the airbag sensor rear LH.

7. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor rear LH with the nut.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor rear LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the airbag sensor rear LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

d. Check that there is no looseness in the installation parts of the airbag sensor rear LH.
e. Connect the connector to the airbag sensor rear LH.

8. INSTALL REAR SEATBACK ASSEMBLY (FIXED TYPE REAR SEAT)
9. INSTALL REAR SEATBACK ASSEMBLY LH (SEPARATED TYPE REAR SEAT)
10. INSTALL REAR SEAT CUSHION ASSEMBLY
11. CONNECT BATTERY NEGATIVE TERMINAL
12. INSPECT SRS WARNING LIGHT