Programming and Relearning
RESET1. RESET THE SLIDING ROOF POSITION DEPENDING ON THE CONDITION OF THE VEHICLE AS SHOWN IN THE TABLE
NOTE:
When the battery negative (-) terminal 18 disconnected or "PWR No.1" fuse is removed due to the repair, the sliding roof position memory is erased. After reconnecting the battery negative (-) terminal, make sure to reset the zero point.
If the reset is not performed, the sliding roof automatic operation will not function
a. Reset A
1. To reset the zero point for the sliding roof, push and hold the switch on the "TILT UP" side until the sliding roof tilts all the way up and down a little automatically.
2. Confirm "one-touch side open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "SLIDE-OPEN" and "TILT-UP" sides.
b. Reset B
1. Push and hold the switch on the "TILT UP/CLOSE" side until the sliding roof stops.
2. Continue to push and hold the switch on the "TILT UP/CLOSE" side for 10 seconds or more. The sliding roof will close to the fully closed position.
3. Continue to push and hold the switch on the "TILT UP/CLOSE" side until the sliding roof tilts all the way up and down a little automatically.
4. Confirm "one-touch side open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "SLIDE-OPEN" and "TILT-UP" sides.
c. Reset C
1. To reset the zero point for the sliding roof, push and hold the switch on the "TILT UP" side until the sliding roof tilts all the way up and down a little automatically.
2. Release the switch, and within 5 seconds re-push and hold the switch on the "TILT UP/CLOSE" side.
3. The sliding roof will automatically move to full slide open and then reverse to the close position.
4. Release the switch.
5. Confirm "one-touch side open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "SLIDE-OPEN" and "TILT-UP" sides.