On-Vehicle Inspection

ON-VEHICLE INSPECTION




1. CHECK WINDOW LOCK SWITCH
a. Check that the front passenger side power window and rear power windows' operation are disabled when the window lock switch of the multiplex network master switch assembly is pressed.
b. Check that the front passenger side power window and rear power windows can be operated when the window lock switch is pressed again.

2. CHECK MANUAL UP/DOWN FUNCTION




a. Check that the driver side power window operates as shown.




b. Check that the power windows except the driver side power window operate as shown.

3. CHECK AUTO UP/DOWN FUNCTION




a. Check that the driver side power window operates as shown.




b. Check that the power windows except the driver side power window operate as follows.




4. CHECK REMOTE MANUAL UP/DOWN FUNCTION
a. Check the power windows except the driver side power window operate as shown.




5. CHECK REMOTE AUTO UP/DOWN FUNCTION
a. Check that the power windows except the driver side power window operate as shown.




6. CHECK JAM PROTECTION FUNCTION

HINT: The jam protection function prevents any part of your body from getting caught by accident between the door frame and the door glass during power window operation.

NOTE: If the power window motor has just been reset, raise and lower the door glass several times using MANUAL function before performing the check.

a. Check that the door glass goes down by approximately 50 mm (1.97 in.) right when something gets caught between the door frame and door glass during power window operation. However, when the opening between the door frame and the door glass is less than 200 mm (7.87 in.), the door glass continues to go down and does not stop until an opening of 200 mm (7.87 in.) is achieved.

Operative conditions:
- AUTO UP (FRONT DOORS)
- AUTO UP/MANUAL UP function after the ignition switch is turned of (FRONT DOORS)