Shift Cable: Service and Repair
TRANSMISSION CONTROL CABLE ASSEMBLY (ATM)REPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
3. REMOVE POSITION INDICATOR HOUSING ASSEMBLY
4. REMOVE CONSOLE BOX UPPER
5. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER
6. REMOVE CONSOLE BOX ASSEMBLY
7. REMOVE CONSOLE BOX FRONT
8. REMOVE AIR BAG SENSOR ASSEMBLY CENTER
9. REMOVE AIR CLEANER ASSEMBLY
10. REMOVE INTAKE AIR RESONATOR SUB-ASSEMBLY
11. REMOVE ENGINE UNDER COVER LH
12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
a. Remove the 2 bolts and disconnect the shift cable grommet retainer No.2.
b. Remove the nut from the control shaft lever.
c. Disconnect the control cable from the control shaft lever.
d. Remove the clip and disconnect the control cable from the control cable bracket.
e. Disconnect the control cable from the control cable clamp.
f. Disconnect the floor shift cable from the transmission floor shift assembly.
g. Pull out the control cable from the body.
h. Remove the shift cable grommet retainer No.2.
13. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
a. Install the shift cable grommet retainer No.2 to the floor shift cable.
b. Put in the control cable to the body.
c. Install the floor shift cable as shown in the illustration.
HINT:
- Install it with the uneven surface facing up.
- Securely engage the claws.
d. Connect the control cable to the control cable clamp.
e. Connect the control cable with a new clip to the bracket.
f. Temporarily install the control cable to the control shaft lever with the nut.
g. Install the shift cable grommet retainer No.2 with the 2 bolts.
Torque: 5.0 Nm (50 kgf-cm, 43 inch lbs.)
14. INSTALL INTAKE AIR RESONATOR SUB-ASSEMBLY
15. INSTALL AIR CLEANER ASSEMBLY
16. INSTALL AIR BAG SENSOR ASSEMBLY CENTER
17. INSTALL CONSOLE BOX FRONT
18. INSTALL CONSOLE BOX ASSEMBLY
19. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER
20. INSTALL CONSOLE BOX UPPER
21. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
22. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
24. ADJUST SHIFT LEVER POSITION
25. INSPECT SHIFT LEVER POSITION
26. PERFORM INITIALIZATION
Some systems need initialization when disconnecting the cable from the negative battery terminal.