Replacement

Starter Assy:

REPLACEMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE AIR CLEANER ASSEMBLY WITH HOSE
3. REMOVE AIR CLEANER INLET NO.1




4. REMOVE STARTER ASSEMBLY
a. Disconnect terminal 50 of the connector from the starter assembly.
b. Open the terminal cap, remove the nut and disconnect the wire harness from terminal 30.




c. Remove the 2 bolts and the starter assembly.

5. INSTALL STARTER ASSEMBLY
a. Install the starter assembly with the 2 bolts.

Torque: 37 N.m (380 kgf.cm, 26 ft.lbf)

b. Connect the wire harness to terminal 30 and install the nut.

Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)

c. Cover the nut with the cap.
d. Connect terminal 50 to the starter assembly.

6. INSTALL AIR CLEANER INLET NO.1
7. INSTALL AIR CLEANER ASSEMBLY WITH HOSE
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION

NOTE: When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.

Initialize Front Power Seat Control System
a. The power seat ECU must be initialized under any of the following conditions.
- The battery is disconnected.
- The D/C CUT fuse is replaced.
- The power seat switch (power seat ECU) is replaced.
- The power seat assembly is removed from the vehicle.

b. Initialize the power seat ECU as follows.
1. Using the seat switches, fully slide the seat forward, fully recline the seatback forward, and fully raise the seat cushion and headrest.
2. Using the seat switches, fully slide the seat rearward, fully recline the seatback rearward, and fully lower the seat cushion and headrest.