Replacement
Generator Assy:
REPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. REMOVE FAN AND GENERATOR V BELT
4. REMOVE GENERATOR ASSEMBLY
a. Disconnect the wire harness clamp.
b. Remove the terminal cap.
c. Remove the nut and disconnect the wire harness from terminal B.
d. Disconnect the generator connector from the generator assembly.
e. Remove the nut from the cylinder block.
f. Remove the 2 bolts and generator assembly.
g. Remove the bolt and wire harness clamp stay.
h. Remove the bolt and bracket.
5. INSTALL GENERATOR ASSEMBLY
a. Install the bracket with the bolt.
Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)
b. Install the wire harness clamp stay.
Torque: 8.4 N.m (86 kgf.cm, 74 in.lbf)
c. Install the generator assembly with the 2 bolts.
Torque: 43 N.m (438 kgf.cm, 32 ft.lbf)
d. Install the nut to the cylinder block.
Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)
e. Connect the generator connector to the generator assembly.
f. Install the generator wire with the nut.
Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)
g. Install the terminal cap.
h. Connect the wire harness clamp.
6. INSTALL FAN AND GENERATOR V BELT
7. REMOVE V-BANK COVER SUB-ASSEMBLY
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
NOTE: When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.
Initialize Front Power Seat Control System
a. The power seat ECU must be initialized under any of the following conditions.
- The battery is disconnected.
- The D/C CUT fuse is replaced.
- The power seat switch (power seat ECU) is replaced.
- The power seat assembly is removed from the vehicle.
b. Initialize the power seat ECU as follows.
1. Using the seat switches, fully slide the seat forward, fully recline the seatback forward, and fully raise the seat cushion and headrest.
2. Using the seat switches, fully slide the seat rearward, fully recline the seatback rearward, and fully lower the seat cushion and headrest.