Compressor Clutch: Testing and Inspection
COOLER COMPRESSOR ASSEMBLY W/ MAGNETIC CLUTCHa. Connect the positive (+) lead from the battery to terminal and the negative (-) lead to the body ground.
b. Check that the magnetic clutch energized.
If operation is not as specified, replace the magnet clutch assembly.
INSPECT MAGNETIC CLUTCH CLEARANCE
a. Set the dial indicator to the magnet clutch hub.
b. Connect the battery positive lead to the terminal 1 of magnet clutch connector and the negative lead to the earth wire. Turn on and off the magnet clutch and measure the clearance.
Standard clearance: 0.35 - 0.60 mm (0.013 - 0.023 in.)
If the measured value is out of the standard range, remove the magnet clutch hub and adjust it with magnet clutch washers.
NOTE: Adjustment shall be performed with 3 or less magnet clutch washers.