Road Test

ROAD TEST

PROBLEM SYMPTOM CONFIRMATION




a. Inspect the SET function.
1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. After releasing the switch, check that the vehicle cruises at the set speed.

b. Inspect the ACC switch.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. Check that vehicle speed increases while the cruise control main switch is pushed to RES/ACC, and that the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily push the cruise control main switch to RES/ACC and then immediately release it. Check that vehicle speed increases by approximately 1.6 km/h (1.0 mph) (Tap-up function).

c. Inspect the COAST function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. Check that vehicle speed decreases while the cruise control main switch is pushed to SET/ COAST, and that the vehicle cruises at the newly set speed when the switch is released.
5. Momentarily push the cruise control main switch to SET/COAST, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (Tap-down function).

d. Inspect the CANCEL function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
- Depressing the brake pedal
- Depressing the clutch pedal (Manual Transaxle)
- Moving the shift lever to any position except D (Automatic Transaxle)
- Pushing the ON-OFF button off
- Pulling the cruise control main switch to CANCEL
Reference: Cruise control will be halted if VSC starts operation while driving.

e. Inspect the RES (RESUME) function.




1. Push the ON-OFF button on.
2. Drive at the required speed (40 km/h (25 mph) or higher).
3. Push the cruise control main switch to SET/COAST.
4. When doing one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
- Depressing the brake pedal
- Depressing the clutch pedal (Manual Transaxle)
- Moving the shift lever to any position except D (Automatic Transaxle)
- Pulling the cruise control main switch to CANCEL

5. After pushing the cruise control main switch to RES/ACC at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed prior to the cancellation.