Without Scan Tool

DTC CHECK (USING SST CHECK WIRE)

Check DTCs using a SST check wire.




1. Using SST, connect terminals Tc and CG of the DLC3.

SST 0984318040

2. Turn the ignition switch to the ON position.




3. Read the DTC from the ABS warning light on the combination meter.

HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.
- As an example, the blinking patterns for a normal system code and codes 11 and 21 are shown.

4. Codes are explained in the code table.

If 2 or more DTCs are detected at the same time, the lowest numbered DTC is displayed first.

5. After completing the check, remove the SST from the DLC3.