Without Scan Tool
DTC CLEARa. Clearing individual DTC memory (when clearing the memory of the DTC detected in the past individually)
1. Press the preset switch "5" for 2 seconds or more while the "ECHN" is displayed in the service check mode or during the detailed information mode.
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory is cleared, only the component code (physical address) is displayed for the target component.
- To check DTCs, press the preset switch "1" and perform the service check again.
b. Clearing all the DTC memory (when clearing all the memory of the DTCs detected in the past)
1. Start the diagnostic mode after repairing the trouble area.
2. Press the preset switch "5" for 2 seconds or more ("CLR" is displayed at this time).
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory for all the components is cleared, only the component codes (physical address) are displayed.
3. Press the preset switch "1" to perform the service check again, and check that no DTCs are displayed for all the component codes (physical address).
c. Finishing Diagnostic Mode.
1. Press the "DISC" or "CD" for 2 seconds or more, or turn the ignition switch off.