Without Scan Tool

DTC CHECK (USING SST CHECK WIRE)

a. Check DTCs.




1. Using SST, connect terminals TC and the CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch on (IG).




3. Read DTCs by the blinking pattern of the ABS warning light.

HINT:
- If the ABS warning light does not blink, inspect the TC terminal circuit or ABS warning light circuit.
- As an example, the blinking patterns for a normal system code and trouble codes 11 and 21 are shown.

4. Codes are explained in the code table.
5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the ignition switch.

If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK/CLEAR

a. Turn the ignition switch on (IG).
b. Check that the ABS warning light goes off after approximately 3 seconds.