Without Scan Tool

Check DTC




1. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch on (IG).




3. Read the number of blinks of the ABS and VSC warning lights.

HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.
- As an example, the blinking patterns for a normal system code and trouble codes 11 and 21 are shown.

4. Codes are explained in the code table.
5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the ignition switch.

If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF CHECK/CLEAR
a. Turn the ignition switch on (IG).
b. Check that the ABS and VSC warning lights go off within approximately 3 seconds.