Troubleshooting

DTC P0974 Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1)

CIRCUIT DESCRIPTION

DTC Detection Condition:

Shifting from 1st to O/D) is performed in combination with ON and OFF of the shift solenoid valve No.1 and No. 2 controlled by ECM. If an open or short circuit occurs in either of the solenoid valves, the ECM controls the remaining normal solenoid valve to allow the vehicle to be operated smoothly (Fail safe function).

Fail safe function:
If either of the solenoid valve circuits develops an open or short, the ECM turns the other solenoid valve ON and OFF to shift to the gear positions shown in the table below. The ECM also turns the shift solenoid valve ST OFF at the same time. If both solenoids malfunction, hydraulic control cannot be performed electronically and must be done manually.

Manual shifting as shown in the above table must be done (In the case of a short circuit, the ECM stops sending current to the short circuited solenoid).

Wiring Diagram:

Step 1 - 2:

Step 3:

INSPECTION PROCEDURE