Engine Torque and Sequence

Part 1 Of 2:

Part 2 Of 2:

Torque Specification

CYLINDER HEAD





Using a bi-hexagon wrench 10, install and uniformly tighten the 10 cylinder head bolts with plate washers, in several passes, in the sequence shown.
First Pass 49 Nm (500 kgf-cm, 36 ft. lbs.)
Second Pass Turn 90°


Cylinder head set bolt Length
Standard 146.8 - 148.2 mm (5.780 - 5.835 inch)
Maximum 148.5 mm (5.846 inch)


INTAKE MANIFOLD
Intake manifold x Cylinder head sub-assy 30 Nm (306 kgf-cm, 22 ft. lbs.)

ROD BEARING CAP TORQUE
Torque 19 Nm (194 kgf-cm, 14 ft. lbs.)

MAIN BEARING CAP TORQUE





Crankshaft bearing cap x Cylinder block sub-assy
1st 44 Nm (449 kgf-cm, 33 ft. lbs.)
2nd Turn 90° (Turn 90°, Turn 90°)





Others 19 Nm (194 kgf-cm, 14 ft. lbs.)


CRANKSHAFT PULLEY
Torque 138 Nm (1,407 kgf-cm, 102 ft. lbs.)

OIL PUMP
Torque 9.0 Nm (92 Kgf-cm 80 inch lbs.)

EXHAUST MANIFOLD
Torque 37 Nm (377 kgf-cm, 27 ft. lbs.)





WATER PUMP
Torque:
Bolt A 9.0 Nm (92 kgf-cm, 80 inch lbs.)
Bolt B 11 Nm (113 kgf-cm, 8 ft. lbs.)