With Manufacturer's Scan Tool

Check the DTC

NOTE:
- If there is no DTC in the normal mode, check the 1St trip DTC using Continuous Test Results function (Mode 7 for SAE J1979) on the OBD II scan tool or hand-held tester.

- Hand-held tester only:
When the diagnosis system is switched from the normal mode to the check mode, all the DTCs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the DTCs and freeze frame data, and note them down.

1. Prepare the OBD II scan tool (complying with SAE J1978) or hand-held tester.
2. Connect the OBD II scan tool or hand-held tester to the DLC3.
3. Turn the ignition switch ON, and push the OBD II scan tool or hand-held tester switch ON.
4. Use the OBD II scan tool or hand-held tester to check the DTCs and freeze frame data and note them down (For operating instructions, see the OBD II scan tool's instruction book).

If there is no DTC in the normal mode, check the 1st trip DTC using Continuous Test Results function (Mode 7 for SAE J1979) on the OBD II scan tool or hand-held tester.

5. See Trouble Code Descriptions to confirm the details of the DTCs.

NOTE:
- When simulating symptoms with an OBD II scan tool (excluding hand-held tester) to check the DTCs, use the normal mode. For code on the DTC chart subject to "2 trip detection logic", perform the following either action.
- Turn the ignition switch OFF after the symptom is simulated the once. Then repeat the simulation process again. When the problem has been simulated twice, the MEL lights up and the DTCs are recorded In the ECM.
- Check the 1st trip DTC using Mode 7 (Continuous Test Results) for SAE J1979.