Removal and Installation
REMOVAL1. REMOVE FRONT DOOR SCUFF PLATE RH
2. REMOVE COWL SIDE TRIM RH
3. REMOVE UNDER COVER
4. REMOVE NO.2 INSTRUMENT LOWER PANEL
5. REMOVE CENTER FINISH CLUSTER PANEL
6. REMOVE ECM
a. Disconnect the connectors.
b. Remove the 2 nuts and ECM.
7. REMOVE AIR DUCT RH (Foot)
Release the 2 claws and remove the air duct.
8. DISCONNECT CONNECTOR BRACKET
a. Disconnect the connectors.
b. Remove the 2 screws and disconnect the bracket.
9. REMOVE BLOWER UNIT
a. Disconnect the connectors.
b. Disconnect the evaporator temperature sensor connector clamp.
c. Remove the bolt, nut and 2 screws.
d. Remove the blower unit.
INSTALLATION
1. INSTALL BLOWER UNIT
a. Install the blower unit with the bolt, nut and 2 screws.
b. Connect the connectors.
c. Connect the evaporator temperature sensor connector.
d. Install air duct (Foot).
2. INSTALL CONNECTOR BRACKET
a. Install the connector bracket with the 2 screws.
b. Connect the connectors.
3. INSTALL ECM
a. Install the ECM with the 2 nuts.
b. Connect the connectors.
4. INSTALL CENTER FINISH CLUSTER PANEL
5. INSTALL NO.2 INSTRUMENT LOWER PANEL
6. INSTALL UNDER COVER
7. INSTALL COWL SIDE TRIM RH
8. INSTALL FRONT DOOR SCUFF PLATE RH