Without Scan Tool

DIAGNOSIS SYSTEM

a. Check the indicator.




When the ignition switch is turned ON, check that the ABS warning light comes on for a few seconds.

HINT: If the indicator check result is not normal, proceed to the troubleshooting for the ABS warning light circuit.

b. Check the DTC.




1. Using SST, connect terminals Tc and E1 of the DLC2 or DLC1.
SST 09843-18020

2. Turn the ignition switch ON.
3. Read the DTC from the ABS warning light on the combination meter.

HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.




- As an example, the blinking patterns for the normal code and codes 11 and 21 are shown in the illustration.

4. Codes are explained in the code table.
5. After completing the check, disconnect terminals Tc and E1 of the DLC1 or DLC2, and turn off the display.
If 2 or more malfunctions are indicated simultaneously the lowest numbered DTC will be displayed first.