Troubleshooting
DTC P0120 Throttle/Pedal Position Sensor/Switch "A" CircuitCIRCUIT DESCRIPTION
DTC Detection Condition:
The throttle position sensor is mounted in the throttle body and detects the throttle valve opening angle. When the throttle valve is fully closed, a voltage of approximately 0.7 V is applied to terminal VTA of the ECM. The voltage applied to the terminals VTA of the ECM increases in proportion to the opening angle of the throttle valve and becomes approximately 2.7-5.2 V when the throttle valve is fully opened. the ECM judges the vehicle driving conditions from these signals input from terminals VTA and uses them as one of the conditions to correct the air-fuel ratio and the power increase, and, also to control the fuel-cut control etc.
HINT: After confirming DTC P0120, use the OBD II scan tool or the hand-held tester to confirm the throttle valve opening percentage and closed throttle position switch condition.
Wiring Diagram:
Step 1:
Step 2 - 3:
Step 4 - 5:
INSPECTION PROCEDURE
HINT:
- If different DTCs that are related to different Systems are output simultaneously while terminal E2 is used as a ground terminal, terminal E2 may be open.
- Read freeze frame data using a hand-held tester or the OBD II scan tool, as freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air-fuel ratio was lean or rich, etc at the time of the malfunction.
CHECK FOR INTERMITTENT PROBLEMS
HINT:
Hand-held tester only:
By putting the vehicle's ECM in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic and the sensitivity to detect open circuits is increased. This makes it easier to detect intermittent problems.
a. Clear the DTC.
b. Set the check mode.
c. Perform a simulation test.
d. Check the connector and terminal.
e. Handle the connector.