Front Seat
REMOVALREMOVE FRONT SEAT
a. Using a screwdriver, remove the seat track covers.
HINT: Tape the screwdriver tip before use.
b. Remove the 4 bolts.
c. Disconnect the seat belt warning light connector.
d. w/ Side airbag:
Disconnect the connector.
NOTE: When disconnect the side airbag connector take care not to damage the airbag and the airbag wire harness.
e. Remove the front seat.
NOTE: Be careful not to damage the body.
INSTALLATION
INSTALL FRONT SEAT
a. Slide the front seat to the most front position.
NOTE: Make sure that seat adjuster locks.
b. Without holding the seat track handle, mount the seat to the vehicle.
HINT: If holding the seat track handle, the adjusted most front positions slip off.
c. Connect the seat belt warning light connector.
d. w/ Side airbag:
Connect the side airbag connector.
e. Tighten the bolts on the rear side temporarily, from the bolt on the inner side tighten them completely.
Torque: 37 N.m (380 kgf.cm, 27 ft.lbf)
f. Slide the seat to the most rear position to install the bolts on the front inner side.
Torque: 37 N.m (380 kgf.cm, 27 ft.lbf)
g. Install the seat track covers.