Pre-Check

NOTE: This is the only information provided by the manufacturer for reading diagnostic trouble codes for this system.

PRE-CHECK

1. OUTLINE OF THEFT DETERRENT SYSTEM
When the theft deterrent system detects any theft, it informs people around with flashing lights and sound.

2. PARTIAL CHANGE OF SYSTEM SETTING METHOD
There are 4 conditions in this system which are disarmed state, arming preparation, armed state and alarm sounding.

1. Disarmed state
- When the alarming function does not operate.
- When theft deterrent function is not performed.

2. Arming preparation
- Time until transferring to armed state.
- Theft deterrent function is not performed.

3. Armed state
When theft deterrent function is possible.

4. Alarm sounding:
In this condition, once theft is detected, it is informed using light and sound to people around the vehicle.




Refer to the table for alarming method or time.

HINT: In the arming condition when either of doors is unlocked with key not in the key cylinder, force lock signal is output.

Indicator Light Output:

3. ACTIVE ARMING MODE




4. ECU TERMINAL VALUES MEASUREMENT BY USING BREAK-OUT-BOX AND HAND-HELD TESTER
a. Hook up the break-out-box and hand-held tester to the vehicle.
b. Read the ECU input/output values by following the prompts on the tester screen.
c. Please refer to the hand-held tester has a "Snapshot" function. This records the measured data and is effective in the diagnosis of intermittent problems.