Antitheft System - RS3000 System Identification
T-SB-0067-11June 28, 2011
Factory Installed RS3000 TVIP
Service Category
Vehicle Interior
Section
Theft Deterrent/Keyless Entry
Market
USA
Applicability
Introduction
Certain 1999 - 2002 model year TMMC built Corolla vehicles are equipped with a factory installed RS3000 security system. This option is in addition to the Dealer Installed Option (DIO) and Post Production Option (PPO) and has identical functions and features as these existing options. For service related purposes this bulletin describes the procedures to identify whether vehicles are equipped with a factory installed or a DIO/PPO system.
Production Change Information
This TSB applies to 1999 - 2002 Corolla vehicles with plant code "C" in the VIN (7th digit from the right) starting with the VIN shown below.
Warranty Information
Identification Procedure
When service of a Corolla Security System is required the steps below should be followed in order to distinguish the factory installed R53000 TVIP from the DIO or PPO (V3) System.
1. Determine the model year from the VIN.
^ If the model year is 1999 - 2002 proceed to step 2.
^ If the model year is 1998 or prior this vehicle has the DIO or PPO installed R53000 TVIP
2. Determine if the vehicle is equipped with the R53000 System Status Monitor and Remote Transmitter as shown in the following illustrations.
^ The Remote Transmitter has two buttons, top and bottom.
^ The Status Monitor has a Toyota label, LED, and microphone.
If the vehicle is equipped with the R53000 System then proceed to step 3.
3. Referring to the Security System Layouts in Figures 3 and 4 of this bulletin, determine the location of the R53000 ECU inside the vehicle without disassembling interior panels.
^ If the R53000 ECU is located under the driver's seat as shown in Figure 3, this vehicle has the DIO or PPO installed R53000 TVIR
^ If the R53000 ECU is NOT located under the driver's seat as shown in Figure 4, this vehicle has the factory installed R53000 TVIP