Cylinder Head Torque and Sequence
INSTALL CYLINDER HEAD BOLTSHINT:
- The cylinder head bolts are tightened in 2 progressive steps (steps (b) and (d)).
- If any cylinder head bolt is broken or deformed, replace it.
a. Apply a light coat if engine oil on the threads and under the heads of the cylinder head bolts.
Tightening Sequence:
b. Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.
Torque:
1ZZ-FE: 49 Nm (500 kgf-cm, 36 ft. lbs.)
2ZZ-GE: 35 Nm (375 kgf-cm, 26 ft. lbs.)
If any one of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.
c. Mark the front of the cylinder head bolt with paint.
d. 1Z-FE: Retighten the cylinder head bolts 90° in the numerical order shown.
e. 2ZZ-GE: Retighten the cylinder head bolts 180° in the numerical order shown.
f. 1ZZ-FE: Check that the paint mark is now at a 90° angle to the front.
g. 2ZZ-GE: Check that the paint mark is now at a 180° angle to the front.
h. Install the bolt holding the water bypass pipe to the cylinder head.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
i. Connect the upper radiator hose to the water hose unions.
j. Connect the heater hose to the water hose unions.