Reassembly

REASSEMBLY

HINT:
- Thoroughly clean all parts to be assembled.
- Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.
- Replace oil seals with new ones.

1. INSTALL VALVES





a. Using SST, push in a new oil seal.
SST 09201-41020





HINT: The intake valve oil seal is light brown and the exhaust valve oil seal is gray.

NOTICE: Pay much attention to assemble the oil seal for intake and exhaust. Assembling the wrong one may cause a failure.





b. Install the valve (1), spring seat (2), valve spring (3) and spring retainer (4).





c. Using SST, compress the valve spring and place the 2 keepers around the valve stem.
SST 09202-70020 (09202-00020)





d. Using a plastic-faced hammer and the valve stem (not in use) tip wound with vinyl tape, lightly tap the valve stem tip to ensure a proper fit.

NOTICE: Be careful not to damage the valve stem tip.

2. INSTALL VALVE LIFTERS
a. Install the valve lifter.
b. Check that the valve lifter rotates smoothly by hand.





3. INSTALL CAMSHAFT POSITION SENSOR
Install the camshaft position sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
4. INSTALL ECT SENSOR
Install a new gasket and the ECT sensor.
Torque: 20 Nm (205 kgf-cm, 15 ft. lbs.)
5. INSTALL OIL PRESSURE SWITCH
a. Apply adhesive to 2 or 3 threads of the oil pressure switch
Adhesive: Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent.
b. Install the oil pressure switch.
Torque: 13 Nm (130 kgf-cm, 10 ft. lbs.)