Disassembly and Reassembly

COMPONENTS

DISASSEMBLY




1. REMOVE NO.2 FUEL SUCTION SUPPORT
a. Using a small screwdriver, remove the No.2 fuel suction support.
b. Remove the rubber cushion and fuel pressure regulator.
c. Remove the O-ring from the pressure regulator.




2. REMOVE NO.1 FUEL SUCTION SUPPORT
a. Disconnect the fuel sender gauge connector.
b. Using a small screwdriver, remove the No.1 fuel suction support.

NOTE: Do not damage the fuel suction support and fuel suction plate.

c. Disconnect the fuel pump harness from the fuel pump.
d. Remove the O-ring from the No.1 fuel suction support.

3. REMOVE VAPOR PRESSURE SENSOR
Pull off the joint clip and remove the vapor pressure sensor from No.1 fuel suction support.




4. REMOVE FUEL PUMP
a. Remove the fuel pump from the fuel filter.
b. Remove the O-ring from the fuel pump.

REASSEMBLY




1. INSTALL FUEL PUMP
Connect the fuel pump to the fuel filter.
2. INSTALL FUEL PRESSURE REGULATOR
a. Install the O-ring to the pressure regulator.

HINT: Apply a light coat of gasoline to a new O-ring, and install it to the pressure regulator.

b. Connect the pressure regulator to the fuel filter.

3. INSTALL NO.1 FUEL SUCTION SUPPORT
a. Connect the fuel pump harness to the No.1 fuel suction support and fuel pump.
b. Install the No.1 fuel suction support to the fuel filter.
c. Connect the fuel sender gauge connector and earth plate.

4. INSTALL NO.2 FUEL SUCTION SUPPORT
a. Install the rubber cushion.
b. Install the No.2 fuel suction support to the No.1 fuel suction support.

5. INSTALL VAPOR PRESSURE SENSOR
Install the vapor pressure sensor and connect the joint clip to the No.1 fuel suction support.