Disassembly and Reassembly

DISASSEMBLY
1. REMOVE SNAP RING
Using snap ring pliers, remove the snap ring.
2. REMOVE AXLE HUB





a. Using Special Service Tool (SST), remove the axle hub.
(SST) 09520-00031 (09520-00040, 09521-00010 09521-00020)





b. Using SST, remove the inner race (outside) from the axle hub.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011), 09950-60010 (09951-00370)
3. REMOVE DUST COVER
Using a torx wrench (T30), remove the 3 bolts and dust cover.





4. REMOVE BEARING FROM STEERING KNUCKLE
a. Place the inner race (outside) on the bearing.
b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09527-17011, 09950-60010 (09951-00600), 09950-70010 (09951-07150)

REASSEMBLY





1. INSTALL BEARING
Using Special Service Tool (SST) and a press, install a new bearing to the steering knuckle.
(SST) 09950-60020 (09951-00680), 09950-70010 (09951-07150)
2. INSTALL DUST COVER
Using a torx wrench (T30), install the dust cover with the 3 bolts.
Torque: 8.3 Nm (85 kgf.cm, 74 inch lbs.)





3. INSTALL AXLE HUB
Using SST and a press, install the axle hub.
SST 09608-32010, 09950-60020 (09951-00680), 09950-70010 (09951-07150)

NOTICE: Be careful not to damage the bearing.

4. INSTALL SNAP RING
Using snap ring pliers, install a new snap ring.