Crankshaft Position Sensor: Service and Repair

REMOVAL

1. REMOVE GENERATOR





2. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
(a) Disconnect the sensor connector from the bracket.
(b) Disconnect the sensor connector from the wiring connector.
3. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the wire clamp from the cylinder block.





(b) Remove the bolt and crankshaft position sensor.

Torque: 9.0 N.m (90 kgf.cm, 80 in. lbf)

INSTALLATION

Installation is in the reverse order of removal.