Front

REMOVAL




1. Disconnect speed sensor connector.
a. Remove the fender liner.
b. Disconnect the speed sensor connector.

2. Remove speed sensor.




a. Remove the 3 clamp bolts holding the sensor harness from the body and shock absorber.

Torque: 5.0 Nm (44 inch lbs.)




b. Remove the speed sensor installation bolt from the steering knuckle.

Torque: 8.0 Nm (71 inch lbs.)

c. Remove the clamp and speed sensor.

NOTE: At the time of installation, please refer to the following item.
- There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
- The sensor is installed flat against the knuckle when you tighten the bolt.

INSTALLATION
Instal in the reverse order of removal. After installation, check speed sensor signal.