Column Shift

REMOVAL

NOTICE: Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)

1. REMOVE THESE PARTS
a. Front seat
b. Center seat belt
c. Center cluster finish panel
d. Lower finish panel assembly
e. Lower No.2 finish panel
f. Glove compartment door
g. Glove compartment
h. Finish panel
i. Center pillar garnish
j. Cowl side trim
k. Front door inside scuff plate
I. Protector

2. REMOVE AIRBAG SENSOR ASSEMBLY

Remove Airbag Sensor Assembly:

a. Peel back the floor carpet.
b. Disconnect the airbag sensor connectors.

NOTICE: Remove the connectors with the airbag sensor assembly installed.

Remove Airbag Sensor Assembly:

c. Using a torx wrench, remove the 4 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

INSTALLATION

NOTICE:
^ Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
^ Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
^ Never repair a sensor in order to reuse it.

Remove Airbag Sensor Assembly:

1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 4 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 21 N.m (210 kgf.cm, 15 ft.lbf)
b. Connect the airbag sensor connectors.

NOTICE:
^ Installation of the connector is done after the sensor assembly has been installed.
^ Make sure the sensor assembly is installed with the specified torque.
^ If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
^ When installing the senor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
^ After installing , shake the sensor assembly to check that there is no looseness.

2. INSTALL REMOVED PARTS