Shifter M/T: Service and Repair

If necessary, replace the control shift lever retainer oil seal.
a. Remove the No.2 inner shift lever set bolt.
b. Remove the No.2 inner shift lever and control shaft. from the control shift lever retainer.





c. Using a screwdriver, pry out the oil seal.





d. Using SST 09304-12012, or equivalent, and a hammer, install a new oil seal.
Drive in depth: 55.7 ± 0.3 mm (2.193 ± 0.012 inch)
e. Install the control shaft and No.2 inner shift lever to the control shift lever retainer.
f. Install and torque the No.2 inner shift lever set bolt.
Torque to: 36 N.m (26 ft. lbs.)