ABS w/o Traction Control

1. Using Special Service Tool (SST) # 09843 - 18020, or equivalent, connect terminals Tc and E1 of Data Link Connector (DLC)2 or DLC1. Remove short pin from DLC1.
2. Place Ignition Switch in ON position.

Clearing DTC By Depressing Brake Pedal:

3. Clear the Diagnostic Trouble Code (DTC) stored in Electronic Control Unit (ECU) by depressing the Brake Pedal 8 or more times within 5 seconds.
4. Check that the warning light shows the normal code.
5. Remove the SST from the terminals of DLC2 or DLC1.

Connecting Short Pin To DLC1:

6. Connect the short pin to DLC1.

NOTE: Disconnecting the battery cable during repairs will not erase the DTC in the ECU.