Preparation For Disassembly

1. M/T: Remove flywheel.
2. A/T: Remove drive plate.





3. Remove rear end plate.
Remove the 2 bolts and end plate.
4. Install engine to engine stand for disassembly.
5. Remove timing belt and pulleys.
6. Remove cylinder head.





7. Remove generator bracket.
Remove the 3 bolts and generator bracket.





8. Remove RH engine mounting bracket.
Remove the 3 bolts and mounting bracket.
9. Remove water pump. Refer to Cooling System.
10. Remove oil filter.
11. Remove engine coolant drain plug.
12. Remove oil pressure switch.





13. Remove knock sensor.
Using Special Service Tool (SST) Oil Pressure Switch Socket # 09816 - 30010 or equivalent, remove the knock sensor.
14. Remove oil pan and oil pump.