Sliding Roof (AISIN Made)

REMOVAL

1. REMOVE ROOF HEADLINING

2. REMOVE SIDE GARNISH

Using a screwdriver, remove the garnishes.

HINT: Tape the screwdriver tip before use.

3. REMOVE SLIDING ROOF GLASS ASSEMBLY

a. Using a torx wrench, remove the 4 screws.

b. Pull the glass upward to remove it.

4. REMOVE DRIVE GEAR

NOTICE: Remove the drive gear with the sliding root is fully closed.

a. Disconnect the connector.






b. Remove the 3 bolts and drive gear.

c. Remove the screw and cam plate cover.






d. Turn the drive gear to align the point marks as shown in the illustration.

e. Install the dam plate cover and screw.

INSTALLATION NOTICE: If the sliding roof position and drive gear full close position is not matched, the sliding roof does not operate normally.

5. REMOVE SLIDING ROOF HOUSING

a. Disconnect the 4 drain hoses from the housing.

b. Remove the 8 bolts and 4 brackets.

c. Remove the 6 nuts, then remove the housing as shown on the following page.

INSTALLATION

Installation is in the reverse order of removal.