Knock Sensor: Testing and Inspection

KNOCK SENSORS INSPECTION

1. Remove throttle body.
2. Remove starter.
3. Remove knock sensors.
- Disconnect the knock sensor connector.





- Using SST, remove the knock sensor.
SST 09816-30010
4. Inspect knock sensors.





- Using an ohmmeter, check that there is no continuity between the terminal and body.
- If there is continuity, replace the sensor.
5. Reinstall knock sensors.





- Using SST, install the knock sensor. SST 09816-30010

Torque: 44 N.m (450 kgf.cm, 33 ft.lbf)

- Connect the knock sensor connector.
6. Reinstall starter.
7. Reinstall throttle body.