Input Signal Check
INPUT SIGNAL CHECKOutput Code
1. (a) For check No.1 - No.3, turn the ignition switch on.
(b) For check No.4 jack up the vehicle, start the engine.
2. Turn the control switch to SET/COAST position or RES/ACC position and hold it down or up 1.
3. Push the main switch on
4. Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly.
5. Turn the SET/COAST switch or RES/ACC position off.
6. Operate each switch as listed in the table below.
7. Read the blinking pattern of the CRUISE MAIN indicator light.
8. After performing the check, turn the main switch off.
HINT: When 2 or more signals are input to the ECU, only the lowest-numbered code is displayed.