Ignition Coil: Service and Repair

IGNITION COILS REMOVAL
1. DISCONNECT HIGH-TENSION CORDS FROM IGNITION COILS



(a) Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
(b) Disconnect the high-tension cord at the grommet. Do not pull on the cord.

NOTICE:
^ Pulling on or bending the cords may damage the conductor inside.
^ Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.

2. REMOVE IGNITION COILS
(a) Disconnect the 3 connectors.



(b) Remove the 3 bolts and 3 ignition coils from the LH cylinder head.

IGNITION COILS INSTALLATION
1. INSTALL IGNITION COILS
(a) Install the 3 ignition coils with the 3 bolts.

Torque: 8 Nm (80 kgf.cm, 69 in.lb)

(b) Connect the 3 connectors.

2. CONNECT HIGH-TENSION CORDS TO IGNITION COILS



(a) Assemble the holder and grommet.
(b) Align the spline of the ignition coil with the spline of the holder, and push in the cord.



(c) Check that the holder is correctly installed to the grommet and ignition coil as shown in the Illustration.
(d) Check that the lock claw of the holder is engaged by lightly pulling the holder.