With Generic Scan Tool

NOTE: Toyota does not provide a method to display DTCs without use of an OBDII scantool.

NORMAL MODE INSPECTION
- When simulating symptoms with an OBDII scan tool (excluding Toyota hand-held tester) to check the diagnostic trouble codes, use Normal Mode.
- For codes on the diagnostic trouble code chart subject to "2 trip detection logic", turn the ignition switch OFF after the symptom is simulated the first time. Then repeat the simulation process again. When the problem has been simulated twice, the MIL lights up and the diagnostic trouble codes are recorded in the ECM.


Malfunction Indicator Lamp Check



1. The malfunction indicator lamp comes ON when the ignition switch is turned ON and the engine is not running.
- If the malfunction indicator lamp does not light up, troubleshoot the combination meter.

2. When the engine is started, the malfunction indicator lamp should go OFF.
- If the lamp remains ON, the diagnosis system has detected a malfunction or abnormality in the system.

Diagnostic Trouble Code Check
1. Prepare the OBDII scan tool (complying with SAE J1978) or Toyota hand-held tester.



2. Connect the OBDII scan tool or Toyota hand-held tester to data link connector 3 (DLC3) in the fuse box at the lower left of the instrument panel.
3. Turn the ignition switch ON and turn the OBDII scan tool or Toyota hand-held tester switch ON.
4. Use the OBDII scan tool or Toyota hand-held tester to check the diagnostic trouble codes and freeze frame data, note them down.
- For operating instructions, see the OBDII scan tool's instruction book.
5. Refer to "Trouble Code Descriptions" to confirm the details of diagnostic trouble codes.
Testing and Inspection